Project: Basic parameters
Track span£º5000mm
Effective cutting width: 4000mm
Track length: 10000mm
Effective cutting length: 7000 mm
Cutting thickness by plasma: 2mm-12 mm
Effective distance to be adjusted at height: 200mm
The positional accuracy and repeated accuracy of whole machine will conform to JB/T5102-1999
The size accuracy to be cut and the quality of cut surface will conform to JB/T10045.3-1999.
Plasma and pressure of The size accuracy to be cut and the quality of cut surface will conform to JB/T10045.4-1999.

Equipment layout

Specification of main equipment

1. Control system
1.1 Micro EDGETM control system imported directly from Hypertherm Company of USA

(1) Main parameters

a. 40G HDD and 1.44M FDD£»
b. P4 processor 2.4GHz, 256MB RAM£»
c. 24 lines of interface signals for cutting and motion logic£»
d. Two axis optically isolated ¡À10V DC drive output and incremental enodal imput.
e. 2¡ÁRS232 Programmable to 115KBavd.
15¡åLCD, industrial three-protection keyboard

1.3 Electric control cabinet: the logic control adapts PLC manufactured by Mitsubishi, Japan

Full digital AC servo motor manufactured by Mitsubishi or Panasonic, Japan
1.4 The vertical and horizontal driving adapts AC servo motor Dual-side drive.
2. Part of machine tool
2.1 Portal vertical big vehicle, the beam adapts square pipe in order to remove stress. The rigid and vibration resistant properties of machine are good. Some of part choose imported product directly. At horizontal, adapts high accuracy fine milled guide rail. The speed reducer adapts NEUGART product, Germany. It features high manufacturing accuracy, low noise and stable when operate.
2.2 Lift system:

Lift device


The adjusting device of lift is the finest in the same industry and is installed at front of small vehicle to control the height of cutting torch. It adapts speed reducer motor to drive screw directly and bring the lift motion of cutting torch. In which the key position that can affect the cutting accuracy of whole machine, i.e. guide lever, adapts double cylinders line guide rail. So that it can guarantee stable up and down motion and the verticality of cut seam.
2.3 Adapts high accuracy mesh between gear and gear without gap transmission.


Precision guide rail and rack
2.4 Adapt horizontal dragging chain protection device.
2.5 Adapt bits scraping system at guide rail.
2.6 Adapt high strength guide rail with and its working surface is grounded by plane grinding machine finely.
2.7 Equipped with solenoid valve, pressure gage, etc. air distributing system.

3. Standard configuration

3.1 There are two groups of movable part at beam. Two groups of movable fractionation install 1 plasma torch respectively with power marker device.
3.2 Two sets of Hypertherm PowerMAX1250 type air plasma cutter of USA£»

3.3 Two sets of Hypertherm increasing device of are pressure type of USA£»(Sensor PHC)

3.41 set of automatic programming software. (FastCAM, Australia)



Submerged Arc Welder



TIG Welder